Study of declination methods while forming the appearance of the surface-to-air unmanned aerial vehicle with a vertical start
https://doi.org/10.26467/2079-0619-2021-24-3-57-70
Abstract
The problem of choosing a rational declination system from alternative variants at the stage of forming the appearance of an unmanned aerial vehicle (UAV) with a vertical launch is considered. Currently, the vertical launch is becoming more widely used for surface-to-air unmanned aerial vehicles, which are considered in this paper. A characteristic initial part of the trajectory of such unmanned aerial vehicles is the declination to the required angular position over a short period of time. The UAV declination process requires the generation of relatively large control moments. Declination of surface-to-air UAVs is implemented by means of moment gas-dynamic control with two main methods – by using the thrust vector control system of the UAV main jet engine or by using special additional gas-dynamic devices. The alternative variants of declination systems for solving the problem under consideration are:
– a thrust vector control system with gas rudders installed in the UAV engine nozzle or just behind its cut-off on special pylons;
– a pulse propulsion system that creates the UAV declination moment by means of jets of micro-thrusters, which are activated by a special algorithm.
In the comparative analysis of declination systems, the criterion for choosing the correct method of declination was the actual near border of the affected zone. The mass minimum of the projected UAV is accepted as the criterion for choosing a rational variant of the declination system. The main relations for calculating the main design parameters of the considered declination systems are given. The appearance parameters of the hypothetical surface-to-air UAV of medium range with alternative declination systems were calculated. A comparative analysis of the results obtained was carried out.
About the Author
A. V. Vindeker
Dolgoprudny Research and Production Enterprise; Moscow Aviation Institute (National Research University)
Russian Federation
Russian Federation
Alexander V. Vindeker, Engineer of Dolgoprudny Research and Production Enterprise, Postgraduate Student of Moscow Aviation Institute (National Research University)
Dolgoprudny
Moscow
References
1. Afanasev, P.P., Golubev, I.S., Levochkin, S.B., Novikov, V.N., Parafes, S.G., Pestov, M.D. and Turkin, I.K. (2010). Bespilotnyye letatelnyye apparaty. Osnovy ustroystva i funktsionirovaniya [Unmanned aerial vehicles. Fundamentals of structure and functioning], in Golubev I.S., Turkin I.K. (Eds.). Moscow, Izdatelstvo MAI, 654 p. (in Russian)
2. Arhangel'skij, I.I., Afanasev, P.P., Bolotov, E.G., Golubev, I.S., Levochkin, S.B., Matveenko, A.M., Mizrohi, V.Ya., Novikov, V.N., Ostapenko, S.N. and Svetlov, V.G. (2013). Proyektirovaniye zenitnykh upravlyaemykh raket [Design of anti-aircraft guided missiles], in Golubev I.S., Svetlov V.G. Moscow: Ekslibris-Press, 764 p. (in Russian)
3. Svetlov, V.G., Arhangel'skij, I.I., Mizrokhi, V.Ya. and others (1998). Sovremennyye sposoby gazodinamicheskogo upravleniya opredelyayut oblik ZUR novogo pokoleniya [Modern methods of gas dynamic control determine the appearance of a new generation anti-aircraft guided missile]. Tekhnika vozdushnogo flota, no. 1. pp. 49–56. (in Russian)
4. Petrash, V.Ya. and Kovalenko, A.I. (2003). Raschet parametrov i kharakteristik letatelnykh apparatov s ustroystvami gazodinamicheskogo upravleniya [Calculation of parameters and characteristics of an aircraft with gas-dynamic control devices]. Moscow: Izdatelstvo MAI, 93 p. (in Russian)
5. Mizrokhi, V.Ya. (2010). Proektirovaniye upravleniya zenitnykh raket [Designing antiaircraft missiles control]. Moscow: Ekslibris-Press, 252 p. (in Russian)
6. Pankratov, O.N. and Chabanov, V.A. (2018). Metody i tekhnicheskiye ustroystva navedeniya sovremennykh raket klassa «vozdukh – vozdukh» [Methods and technical guidance devices for modern air-to-air missiles]. Aviatsionnyye sistemy, no. 5, pp. 35–39. (in Russian)
7. Tekin, R. (2010). Design, modeling, guidance and control of a vertical launch surface to air missile. Master’s thesis, Middle East Technical University, 153 p.
8. Zhandildinova, K.M. and Moldabekov, A.K. (2020). Ummanned aerial vehicle control with a wing circulation system. Bulletin of the Academy of Civil Aviation, no. 1 (16). pp. 33–37.
9. Dunaev, V.A., Nikitin, V.A. and Stolbovskoy, V.N. (2011). The research of the gas rudder form influence on draught losses size in the course of firm fuel rocket engine work by means of mathematical modeling. Izvestiya Tulskogo gosudarstvennogo universiteta. Tekhnicheskiye nauki, no. 2, pp. 68–74. (in Russian)
10. Stolbovskoy, V.N. (2011). The research of the gas rudder data influence of firm fuel rocket engine and its turn angle on draught losses and operating effort. Izvestiya Tulskogo gosudarstvennogo universiteta. Tekhnicheskiye nauki, no. 2, pp. 75–81. (in Russian)
11. Shestakov, I.A., Fedotov, A.Yu. and Shushkov, A.A. (2014). Matematicheskoye modelirovaniye sistemy upravleniya atmosfernogo letatelnogo apparata [Mathematical modeling of the atmospheric aircraft control system]. Matematicheskoye modelirovanie v estestvennykh naukakh, vol. 1, pp. 307–309. (in Russian)
12. Timarov, A.G., Efremov, A.N. and Bulbovich, R.V. (2016). Numerical simulation of jet vane carry-over effect on steering effort. Journal of "Almaz-Antey" Air and Space Defence Corporation, no. 3, pp. 47–51. (in Russian)
13. Timarov, A.G., Efremov, A.N. and Bulbovich, R.V. (2017). Some issues of calculation of steering efforts of rocket motor jet vanes. Vestnik Permskogo natsionalnogo issledovatelskogo politekhnicheskogo universiteta. Aerokosmicheskaya tekhnika, no. 48, pp. 35–42. DOI: 10.15593/2224-9982/2017.48.04 (in Russian)
14. Vindeker, A.V. and Parafes, S.G. (2018). Choice of structural material and external gas rudder geometry of declination system of unmanned aerial vehicle. Civil Aviation High Technologies, vol. 21, no. 1, pp. 67–76. DOI: 10.26467/2079-0619-2018-21-1-67-76 (in Russian)
15. Yakovlev, G.A. and Masaltseva, E.M. (2018). Modeling the flight course of vertical launching rockets. Tekhnika XXI veka glazami molodykh uchenykh i spetsialistov, no. 17, pp. 393–402. (in Russian)
16. Chen, Q. (1995). Comparison of different k-ε models for indoor air flow computations. Numerical Heat Transfer, Part B: Fundamentals, vol. 28, issue 3, pp. 353–369. DOI: 10.1080/10407799508928838
17. Lin, C.L., Lin, Y.P. and Wang, T.L. (2009). A fuzzy guidance law for vertical launch interceptors. Control Engineering Practice, vol. 17, no. 8, pp. 914–923. DOI: 10.1016/j.conengprac.2009.02.008
18. Tekin, R., Atesoglu, O. and Leblebicioglu, K. (2010). Modeling and vertical launch analysis of an aero- and thrust vector controlled surface to air missile. AIAA Atmospheric Flight Mechanics Conference. DOI: 10.2514/6.2010-7639
19. Murty, C., Rao, M.S. and Chakraborty, D. (2010). Numerical simulation of nozzle flow field with jet-vane based thrust vector control. Proceedings of the Institution of Mechanical Engineers Part G Journal of Aerospace Engineering, vol. 224, issue 5, pp. 541–548. DOI: 10.1243/09544100JAERO677
20. Tekin, R., Atesoglu, O. and Leblebicioglu, K. (2013). Flight control algorithms for a vertical launch air defense missile. Advances in Aerospace Guidance, Navigation and Control, pp. 73–84. DOI: 10.1007/978-3-642-38253-6_6
21. Murty, C. and Chakraborty, D. (2015). Numerical characterisation of jet-vane based thrust vector control systems. Defence Science Journal, vol. 65, no. 4, pp. 261–264. DOI: 10.14429/dsj.65.7960
22. Du, W., Zhou, H. and Chen, W. (2016). Trajectory optimization for agile-turn of vertically launched missile. 2016 IEEE International Conference on Mechatronics and Automation, pp. 2110–2115. DOI: 10.1109/ICMA.2016.7558892
23. Yogesh, M. and Hari Rao, A.N. (2016). Solid particle erosion response of fiber and particulate filled polymer based hybrid composites: a review. Journal of Engineering Research and Applications, vol. 6, issue 1, (part–4), pp. 25–39.
24. Petrash, V.Ya. (2007). Metody i modeli avtomatizirovannogo proektirovaniya letatelnykh apparatov [Methods and models of computer-aided design of aircraft]. Moscow: Izdatelstvo MAI, 92 p. (in Russian)
25. Petrash, V.Ya. (2009). Osobennosti avtomatizirovannogo proektirovaniya bespilotnykh letatelnyh apparatov s aerogazodinamicheskim upravlenyem [Features of computer-aided design of unmanned aerial vehicles with aerogasodynamic control]. Moscow: Izdatelstvo MAI-PRINT, 95 p. (in Russian)
26. Petrash, V.Ya. (2020). Ballisticheskoye i massovo-geometricheskoye proektirovaniye bespilotnykh LA v uchebnoy SAPR [Ballistic and mass-geometric design of unmanned aircraft in training CAD]. Moscow: Izdatelstvo MAI, 100 p. (in Russian)
Review
For citations:
Vindeker A.V. Study of declination methods while forming the appearance of the surface-to-air unmanned aerial vehicle with a vertical start. Civil Aviation High Technologies. 2021;24(3):57-70. (In Russ.) https://doi.org/10.26467/2079-0619-2021-24-3-57-70
Views:
610
Email this article 
